DUROFIX RZ1230 Produktinformationen Seite 11

4. Insert tube into the carriage.
5. Push the rod handle forward until the piston is against the tube.
6. Push the Control Lever to the left position.
7. To remove the tube, push the Control Lever to the right position and pull the rod
handle back. Lift the tube out of the carriage.
INSTALLING SAUSAGE TYPE PACK
Always check sausage packs for punctures or damage before installing. Do not use a
damaged or frozen pack.
1. Push the Control Lever to the right position. Remove the battery pack.
2. Pull the rod handle back to allow the pack to fit inside the barrel.
3. Insert pack into barrel.
4. Cut off end of sausage pack per manufacturer's recommendation.
NOTE:
Before using a partially filled pack, remove any hardened material.
5. Insert nozzle supplied with the sausage pack into the nozzle cap and screw onto the
barrel.
6. Cut nozzle at an angle and size per manufacturer's recommendation to suit the job
(unless the nozzle is pre-cut). A smaller nozzle diameter requires more force to push
the caulk and reduces battery life.
7. Push the rod handle forward until the piston is against the pack.
8. Push the Control Lever to the left position
WARNING
accessories specifically recommended for this tool. Others may be hazardous.
WARNING
safety goggles or glasses with side shields.
ANTI-DRIP AND ROD RELEASE
The caulk gun features an automatic anti-drip to prevent drips after the trigger is
released.
END OF TRAVEL
When a tube is emptied, the motor will automatically reverse to release pressure, then
shut off. Release the trigger and change the tube.
OVERLOAD
When an overload occurs, the tool will reach the maximum drive force and continue to
hold this maximum force until the user releases the trigger. If material is not dispensing,
make sure that:
• Nozzle tip is cut
1English1
Always remove battery pack before changing or removing accessories. Only use
To reduce the risk of injury, keep hands away from all moving parts. Always wear
English -10