DUROFIX RZ1230 Produktinformationen Seite 10

A
B
TO REMOVE BATTERY PACK: Depress the battery release button (C) and pull
battery pack (B) out of tool (A). (see Fig. 2)
TO INSTALL BATTERY PACK: Push battery pack (B) onto tool until it locks in
place. (see Fig. 2)
INSTALLING THE CARRIAGE OR BARREL
Use only rods and carriages specifically designed for the Caulking Gun. Other rods and
carriages may cause damage to the tool. Place the carriage over the piston and rod.
Hold the carriage collar securely while screwing the carriage into the collar.
INSTALLING CAULK OR ADHESIVE TUBE
Always check tubes for punctures or damage before installing. Do not use a damaged
or frozen tube.
1. Cut nozzle of tube at an angle and size per manufacturer's recommendation to suit
the job (unless the nozzle is pre-cut). A smaller nozzle diameter requires more force
to push the caulk and reduces battery life.
2. Break the inner seal of the tube. If the inner seal is not broken, the caulk material
may be forced out the rear end of the tube and damage the tool.
Tube Nozzle (Cut open at angle)
NOTE:
Before using a partially filled tube, remove any hardened material with a long nail or piece of wire.
3. Pull the rod handle back to allow the tube to fit inside the carriage.
1.
WARNING
can be pinched between carriage and the piston.
2.
1English1
OPERATION
Use Pin to break open inner seal
To reduce the risk of injury, keep hands out of the piston area of the tool. Fingers
English
Fig. 2
-9
C