Ultimaker S8 Bedienungsanleitung Seite 4

Setup without Material Station
Take the following steps to install the UltiMaker S8 without the Material Station. You will need the spool
holder from the starter kit and the power cable.
Other items included in the starter kit will be installed in the guided welcome setup, or are only
required for maintenance or calibrations (not for first use).
1. Disconnect the Air
Manager cable tip
from the clips and
connect it to the
UMB OUT port.
Setup with Material Station
If the UltiMaker S8 is going to be used in combination with the Material Station, some steps are
different. You do not need the spool holder, but you need several accessories included with the
Material Station instead.
Consult the Material Station quick start guide for additional installation information.
1. Connect the
Material Station
cable from UMB IN
to the UMB OUT
port on the printer.
A mains socket with a protective earth/ground terminal must be used. Make sure that the building
installation has dedicated means of over-current and short-circuit protection.
UltiMaker S8 Quick start guide
2. Insert the spool
holder into the back
panel and push until
it snaps into place.
2. Connect the Air
Manager cable
to the UMB OUT
port on the
Material Station.
3. Connect the spool
holder cable to the
NFC socket and
secure behind the
cable clips.
3. Connect the
power extension
cable to the
UltiMaker S8 and
the Material Station.
4. Connect the power
cable to the printer
and the other end to
a power outlet.
4. Connect the
power cable to the
Material Station and
the other end to a
power outlet.