Connection With A (Smart) Speaker - Canton Smart Sub 10 Anleitung

English
CONNECTION WITH A (SMART) DEVICE
WIRELESS
In wireless mode, the wireless Smart loudspeaker resp Smart amplifier
(master) and the Smart Sub 10 (slave) are connected via a high-end radio link
A frequency of 5 8GHz guarantees a robust and lossless data transmission
Once the Smart Sub 10 has been successfully connected to the Smart loud-
speaker / amplifier, the subwoofer is activated and the wireless connection is
established automatically The input selector switch on the Smart Sub 10 must
be set to WIRELESS [POWER AUTO] (factory setting) If the Smart device is
switched off, the Smart Sub 10 also switches off automatically and the status
LED at the Smart Sub 10 lights up red During operation (wireless as well as
wired) the status LED shines green
SMART WIRED
When using a Smart device with SUB OUT connector, you have the option of
controlling the Smart Sub 10 wirelessly (on/standby, volume, etc ) but still
supplying the audio signal via signal cable To do this, you must connect
(pair) the Smart Sub 10 to the Smart device as described below, then set the
connection type there from wireless to wired and finally set the input selector
switch on the Smart Sub 10 from WIRELESS [POWER AUTO] to WIRED
[POWER AUTO]
WIRED
The input SUB IN [WIRED] is used to connect the Smart Sub 10 via RCA signal
cable For this, the input selector switch of the subwoofer must be set to
„WIRED [POWER ON]" (if the Smart Sub 10 shall stay active, permanently),
or to „WIRED [POWER AUTO]" (if it shall switch on and (delayed) off with the
Smart speaker / amplifier)
3 2 7