Product Assembly - Jumbo Ayce Rta 25 Kit Bersetzung Der Originalbetriebsanleitung

Insert the mains plug
Plug the power cable into the mains socket..Make sure that the mains voltage cited on
the charging station complies with the voltage supplied by your socket. The green light
on the right side of the changing station would blink.
Slide the rechargeable battery (14) into the charging station (17). It can only be inserted
in one position. The battery charging process now begins and is signaled by the red
indicator light on left side of charging station (17). The 4 green LEDs on battery (14) light
up in turn.
14
Once the rechargeable battery has been fully charged, the indicator light on right side of
charging station turn to green. The charging process ends automatically. The 4 green
LEDs on battery light up.
• Charging takes approx. 1-1.2 hours. The battery heats up during the charging process.
This is normal and does not signal a fault. Remove the rechargeable battery after no
more than 5 hours.
Note : Occasionally, the permissible temperature range may be exceeded during the
charging cycle.
In this case, the electronic charging control interrupts the charging cycle to avoid any
damage to the battery.
The read control light will then glow continuously. If you should witness this, pull the
battery from the charging station and let it cool down for about 30 minutes. Then, restart
the charging cycle by sliding the battery back onto the charging station.
• It is not required to monitor the charging time.
• Pull the plug of the charging unit if it is not in use.
• If the battery is not lit up, check if there is electric current in the socket. If the charging
of the batteries is not possible, give the battery charger and the batteries to a service
shop.
Push the button X to check the charging level
The following indications may occur:
• 3 or 4 control lights are glowing: the battery is fully charged.
• 2 control lights are glowing: the charging level is still acceptable.
• 1 control light is glowing: the battery is discharged. Recharge the battery immediately!
Note ! The battery (14) will not reach its full capacity when charged for the first time. The
red light illuminates untill the power cable (16) is disconnected from the mains. Multiple
charging cycles may be required in order to reach the maximum charge.
Note : The battery is equipped with a deep-discharge protection feature: the tool is
automatically switched off if the battery is discharged. Recharge the battery immediately
if this should be the case.
Note :
• When charger is connected to mains socket, but without battery charging, the right
side green LED of the charging station would light up and the left side red LED
extinguish.
• When charging the battery, the left side red LED of the charger station illuminates
(green LED extinguishes) and the 4 green LED on the battery light up in turn.
• When the battery is fulled charged, the right side green LED of the charger station
illuminates (red LED extinguishes) and the 4 green LED on the battery light up.
• When too high temperature warming, the green LED on the charge station keep
illuminates.
• When abnormal situation and charging process is prohibit, the green LED on the
charge station illuminates.
Thermal and voltage protection
If the tool is subject to excessively high loads for an extended period, the rechargeable
battery may switch off. If this occurs leave the battery to cool down for approx. 30
minutes.
To remove, press the release button, and pull out the battery.
• Pull out the mains pluge.

PRODUCT ASSEMBLY

Do not use the trimmer in rain or for cutting wet grass!
Check the grass trimmer flex and its connections before each and every use for visible
signs of damage
(disconnect the battery)! Do not use a faulty flex.
Gloves:
Protective gloves must be worn when using the grass trimmer.
92| 93 GB