Jumbo Ayce RTA 25 KIT Bersetzung Der Originalbetriebsanleitung Seite 46

LIST OF MAIN PARTS
4
13
11
12
8
9 10
1. On/off switch
2. Switch-on inhibit
3. Handle
4. Additional handle
5. Handle support bracket
6. Telescopic tube
7. Height adjustment
8. Motor angle adjustor
9. Blade
2
3
1
14
5
7
6
16
14
15 17
10. Protective cover
11. Edge cutter adjustor
12. Edge cutter training wheel
13. Manopola dell'impugnatura
14. Handle knob
15. Battery interlock
16. Power supply cable
17. Charging station
ASSEMBLY
Open the box
-Open the packaging and remove the device carefully.
-Remove the packaging material as well as the packaging and transport bracing
(if available).
-Check that the delivery is complete.
-Check the device and accessory parts for trans-port damage.
-If possible, store the packaging until the warranty period has expired
Charging process
NOTE :
The batteries are not fully charged on delivery. Before first use, fully charge the
batteries. See charger instruction manual..
Chargers are exclusively suitable to charge these replaceable batteries: LBB25R.
Charging any other battery is not allowed.
Do not use this product in any other way as stated for normal use. Not observing general
regulations in force and instructions from this manual does not make the manufacturer
liable for damages.
CHARGING PROCESS
CAUTION !
Use only original batteries in the supplied battery charger.
NOTE:
• Press the power showing bottom it would show the battery power percentage.
• Put the battery into the slot of charger，Make sure the battery and charger is fully
connected.
90| 91 GB
14
17