Installation - Jeti Model Sp-15-Opto Bedienungsanleitung

Elektronic Switch Elektronic Switch

2.3 Installation

1. apply only new high quality connectors, which must be
soldered properly to the input and output cables of the
switch (look out for remnants of solder flux on the
connectors)
2. connect the JR connector to the receiver output you want
to use for controlling the switch (the controlling part of
the SP 06 switch obtains its current supply from the
receiver)
3. switch on the transmitter and receiver in order to set up
the switching instant of the switch without load, a LED
indicates the ON anf OFF states of the switch (LED alight –
SP is ON)
4. by means of the trimmer and the respective control
element of the transmitter you may adjust the switching
instant
5. with the jumper position choose the ON or OFF function
in accordance with the Tx control element position
6. connect the load to the switch output cables with the + -
marks
7. connect the switched voltage to the inputs with the
marks + - on the ACCU side (watch the correct polarity of
the battery)
8. check the switching function
22
EN