Installation - Jeti Model Sp-15-Opto Bedienungsanleitung

Elektronic Switch Elektronic Switch

1.2 Installation

L3
JR
JR
L3
• Connect the 5-16V (2S or 3S battery) power supply to the
input marked "IN" (watch the correct polarity of the
battery +/-).
• If the switch is closed, the same voltage from the input is at
the output marked "OUT".
• Connect the JR connector from the switch to the receiver
on the servo output, with which you want to turn the
switch on/off.
• The green diode "L1" (power on) indicates the voltage
connected to the JR connector (the control part of the SP
L1
L2
16
EN
Batt
Batt