Additional Safety Instructions For Sanding; Before Use; Checking The Product And Scope Of Delivery; Folding The Handle Out/In (Fig. A) - Walter R7237B-F Bedienungsanleitung

Before Use

b) Never place your hand near the rotating
tool bit. Accessory may kickback over
your hand.
c) Do not position your body in the area
where power tool will move if kickback
occurs. Kickback will propel the tool
in direction opposite to the disc's
movement at the point of snagging.
d) Use special care when working corners,
sharp edges etc. Avoid bouncing and
snagging the accessory. Corners, sharp
edges or bouncing have a tendency to
snag the rotating accessory and cause
loss of control or kickback.
e) Do not use chains or serrated saw
blades. Such tool bits frequently cause
kickback and loss of control over the
power tool.
Additional safety instructions
for sanding

Additional safety instructions for sanding:

a) Do not use excessively oversized
sanding disc paper. Follow
manufacturers recommendations,
when selecting sanding paper. Larger
sanding paper extending beyond the
sanding pad presents a laceration hazard
and may cause snagging, tearing of the
disc or kickback.
Before Use
WARNING!
Do not use the product in potentially
explosive atmospheres. Use the product
only in ambient temperatures between
10 - 40°C.
Disconnect the product from the power
source before making any settings,
mounting or replacing accessories and
carrying out maintenance.
28
630607_Buch_DE_EN_FR_CZ_SI.indb 28 630607_Buch_DE_EN_FR_CZ_SI.indb 28
Checking the product and scope of
delivery
WARNING!
Risk of suffocation! There is a risk of
suffocation by ingestion or inhalation of
films. Keep the packaging film out of the
reach of children.
• Take the product and the accessories out of
the packaging.
• Check that the delivery is complete (see
section "Scope of delivery / Description of
parts").
• Check whether the product or the accessories
are damaged.
• Do not use the product if it is damaged or
parts are missing. Contact the service centre
listed on the warranty card.

Folding the handle out/in (Fig. A)

• Fold the front handle 12 and middle handle
1 out.
• Insert the safety lever 13 in the holder on
the front handle.
• Press the safety lever so that it is flush with
the middle handle.
• Check if the connection is tight.
Mounting / replacing
the extension (Fig. B)
• Loosen the cap nut on the extraction nozzle
4 .
• Fit the extension B to the extraction nozzle.
• Tighten the cap nut of the extraction nozzle.
28.06.2021 09:49:17 28.06.2021 09:49:17