Quick Start Guide; Suspension/Tire Set-Up; Adjusting Saddle Height; Charging The Battery - Pivot Cycles Shuttle Sl Bedienungsanleitung

Suspension/Tire Set-up

Body Weight in [kg] to [bar] 0.15 × Body Weight [kg] = [bar]
Shock Air Pressure
Body Weight in [kg] to [psi]
(by Body Weight)
Body Weight in [lbs] to [bar] 0.07 × Body Weight [lbs] = [bar]
*Always check sag
Body Weight in [lbs] to [psi] Body Weight [lbs] = Body Weight in [psi]
Shock Compression Damping
Shock Rebound Damping
Fork Air Pressure
Fork Compression Damping
Fork Rebound Damping
Front Tire Pressure
Rear Tire Pressure
* These Adjustments are not available on all builds.

Adjusting Saddle Height

1. Use a 2mm hex wrench to loosen the drive side cable port cap securing the dropper post housing.
2. Using a 4mm hex wrench, loosen the seat post clamp bolt and raise/lower the saddle to the preferred height.
3. Using a 4mm hex wrench, tighten the seat post clamp bolt to 5 [Nm].
4. Tighten the cable port cap screw with a 2mm hex wrench to secure the dropper post housing.

Charging the Battery

NOTE: The battery does not come fully charged and must be completely charged before the first use.
1. Prepare the charger by plugging the power cable into the power inverter.
2. Connect the charger to an outlet.
3. Open the magnetic cover over the bikes charging port.
4. Plug the power cable into the bikes charging port.
To ensure a full charge, wait until the LED on the charger switches from red to green.
1

Powering the System ON and OFF

NOTE: The system will automatically turn itself off after extended non-activity.
1. Locate the ring controller on the handlebar.
2. Power the system on by pressing up on the controller for at least 2
seconds. The five LEDs on the LED Hub will illuminate.
3. Once the power-up sequence is complete, the lights will illuminate to indicate the battery charge level.
(1 LED = 0-20%, 2 LEDs = 20-40%, 3 LEDs = 40-60%, 4 LEDs = 60-80%, 5 LEDs = 80-100%)
4. To turn off the system, press and hold the ring controller down for 1 second.
Changing Levels of Support
Increase support by briefly pushing up on the switch. To decrease support briefly push down on the switch.
The 5 LEDs in the LED Hub on the top tube will illuminate in different colors for each support mode.
White LEDs White LEDs No Support- as if you were riding a conventional bike.
Green LEDs Green LEDs Breeze- low but effective support for maximum range.
Blue LEDs Blue LEDs River- reliable support for most applications.
Pink LEDs Pink LEDs Rocket- maximum support for very demanding terrain.
www.pivotcycles.com
2.2 × Body Weight [kg] = [psi]
8 clicks in from OPEN*
6 clicks in from OPEN
75 [psi] / 5.17 [bar]
HSC: 2 clicks in from OPEN*; LSC: 5 clicks in from OPEN
HSR: 3 clicks in from OPEN*; LSR: 7 clicks in from OPEN
23 [psi] / 1.58 [bar]
28 [psi] / 1.93 [bar]
2
info@pivotcycles.com
3
ON
2 sec.
Ring
Control
LED Hub
1.877.857.4868

QUICK START GUIDE

4
OFF
1 sec.
Ring
Control
Increase
Decrease
Ring Control
2mm
1