Product Care And Maintenance - Renpho R-X002 Bedienungsanleitung

3. Press" "to turn on/off and switch the SPA mode. There are 3 modes to choose from:
Mode 1: Bubble only
Mode 2: Bubble + Vibration
Mode 3: Vibration only
4. Press" "to choose the timer among 30, 45, and 60 minutes. The screen will show
current timer when you press this button. When the timer remains 5 minutes, the
machine will beep. When time is up, the machine will automatically shut off and show
"OF" on the display screen.
2.2 Operation Guide
STEP 1. Place the machine on a level surface. Ensure that the massager is unplugged before
adding water.
STEP 2. Add clean water directly to the tub (adding hot water will save your waiting time).
Make sure the water is beyond the Min Water Line but below the Max Water Line. Plug the
machine in and turn it on. Set the water temperature and wait until the water reaches your
desired temperature. You can choose not to use the heating function while still using other
spa modes.
STEP 3. Sit down and put your feet in the tub.
STEP 4. Press buttons on the control panel to set the temperature, timer, and spa mode.
STEP 5. Enjoy your deep spa massage.
To empty: Pour water out of the tub from the side opposite to the control panel.
For a better spa experience
Add bath salt, a few drops of aromatherapy oil or anything you need for your bath. You
can detach the Pedicure Stone and put foot bath powder into your bath.
Do not add large amounts of essential oil to avoid damaging the material of the
product in the long run.
Note:
1. When using or cleaning the massage rollers, please do not press down or tread hard to
avoid damaging the machine as well as affecting the massage effect.
2. Every foot spa massager has been tested with water before leaving the factory to
ensure its functions are well. You may find it's a little wet in the foot spa massager area
but there is no need for concern.
3. Water will continuously lose heat, so in order to keep the water hot, the actual heating
temperature will be a little higher by no more than 5 degrees.

PRODUCT CARE AND MAINTENANCE

Cleaning
Unplug the unit and allow it to cool before cleaning. Clean only with a soft, damp cloth
and mild cleansing agent.
After cleaning, wipe surfaces with a dry cloth.
Never use strong abrasives, detergents or cleaning agents.
Periodically straighten cord if it becomes twisted.
Storage
Unplug the appliance from the outlet and allow it to cool and dry.
Place the appliance in its box or store it in a cool, dry area.
Do not hang the unit by the power cord.
EN-05