Product Care And Maintenance; Troubleshooting Guide - Renpho Rp-Fm058R Bedienungsanleitung

Product Care and Maintenance

1. Unplug the appliance and allow it to cool before cleaning. You can use a soft cotton cloth dampened
with neutral detergent to wipe it clean.
2. The use of non-rated voltage not (DC 12V, 2.5A) is prohibited.
3. It is prohibited for non-professional personnel to repair the appliance or replace parts.
4. If the power adapter is damaged, it must be replaced by the maintenance department or quali ed
personnel approved by the manufacturer so as to avoid potential hazards.
5. Do not use or store the appliance in wet environments or high temperatures.
6. Do not use sharp objects to handle the appliance in order to avoid damage.

Troubleshooting Guide

Problem
The massager
does not work
The massage intensity
is too high or too low
No heating or
insu cient heating
The touch panel is not
working properly
Cause
1. Disconnected power or
loose plug causing poor
contact.
2. The power button is o
or the timer has been
reset.
3. The motor auto
shuts-o due to the
device being on too long
activating overheating
protection.
1. Your foot is positioned
at the wrong angle.
2. Didn't choose intensity
level which is right for you.
1. The heating function is
turned o .
2. The product structure
and working principle
limits how fast the bottom
can heat up. Therefore, the
heating-up may seem a bit
slow, 7-10 minutes before
you can feel the obvious
heat.
1. The plastic lm on the
touch panel is not
removed.
2. Fingers are wet.
3. Insu cient touch area.
EN-06
Solution
1. Re-plug to the power source.
2. Turn on the power button.
3. Use the massager after the
motor cools o naturally.
1. Adjust the contact angle to get moderate
intensity.
2. The massager has 4 intensity levels, choose
the intensity you prefer. We recommend low
intensity to begin with. Or individually choose
air pressure or kneading function to reduce the
intensity.
1. Turn on the Heat Button.
2. It takes about 7-10 minutes to fully
heat up. Please be patient as this is to
avoid the temperature rising too fast.
1. Remove the plastic lm before use.
2. Dry your ngers before touching the
button.
3. Use your thumb to press buttons to
get better touch sensitivity.