Disposal Of The Used Lamp For The Customers In The Usa - Sony VPL-MX25 Bedienungsanleitung

5
Insert the new lamp all the way in until it is
securely in place (a). Tighten the two
screws (b). Fold down the handle to
replace it (c).
Fold down
the handle.
Notes
• Be careful not to touch the glass surface of
the lamp and a inside conductor.
• Insert the handle firmly to attach it
securely.
• The power will not turn on if the lamp is not
secured properly.
6
Close the lamp cover and tighten the two
screws.
Note
Be sure to attach the lamp cover securely as it
was. If not, the projector cannot be turned on.
7
Turn the projector back over.
8
Connect the power cord.
?
The /1 key lights in red.
9
?/1
Press the key to turn the projector on.
10
Press the MENU key, and then select the
Setup menu.
11
Select "Lamp Timer Reset", and then press
the ENTER key.
"Settings for Lamp replacement. Has the
projection Lamp been replaced?" is
displayed in the menu screen.
Lamp Timer Reset
Settings for Lamp replacement.
Has the projection Lamp been replaced?
Yes
12
Select "Yes" with the
press the ENTER key.
The Lamp Timer is initialized to 0, "Lamp
Timer Reset Complete!" is displayed in the
menu screen.
13
Select "Yes" and press ENTER key.
Note
To erase a message, press any key on the control
panel of the projector or on the Remote
Commander.
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be
regulated due to environmental
considerations. For disposal or recycling
information, please contact your local
authorities or the Telecommunications
Industry Association (www.eiae.org).
Replacing the Lamp
No
b
key, and then
11
GB