Problems Diagnosis; Warranty And Service - Murray Mu-Bat-Cs30-Kit Bedienungsanleitung Und Garantiekarte

User manual and warranty card

PROBLEMS DIAGNOSIS

TROUBLESHOOTING
Problem
Chain saw does not
engage.
The chain saw is
intermittent.
Chain / guide
overheated.
Low efficiency of
work.
Hot housing of the
appliance.

WARRANTY AND SERVICE

The product purchased by you is intended for amateur (hobby) use only. If the equipment is
used for other purposes (commercial, professional), it will lose the guarantor's liability for
the purchased equipment. You can find information on the warranty and the MURRAY
service network in the attached warranty card.
Possible cause
Discharged battery.
Faulty switch.
Loose connection.
Faulty internal wiring.
Faulty on/Off switch.
Chain too tight.
A dull chain.
Chain too loose.
Dull or worn chain.
The chain teeth are pointing in
the wrong direction.
Blocked air vents.
The appliance is overheated.
Solution to the problem
Charge the battery.
Contact your service personnel.
Contact your service personnel.
Adjust chain tension.
Sharpen or replace chain.
Adjust chain tension.
Sharpen or replace chain.
Install the chain correctly.
Blow with compressed air.
Stop operation and wait at least
10 minutes.
30
English