Murray MU-BAT-CS30-KIT Bedienungsanleitung Und Garantiekarte Seite 27

User manual and warranty card English
With a fine brush, brush or cloth, clean the housing from dust, you can clean the housing
with compressed air.
It is acceptable to clean with a damp cloth, but only if the appliance immediately dries
immediately after this operation. Protect the metal parts with oil.
Clean the vents regularly with compressed dry air. Do not insert sharp objects into the vents.
When you are done, you must:
• Wipe the air vents and leave them free of dirt.
• Wipe the saw with a dry cloth.
• Do not leave the charger power cord bent.
Attention! Never use aggressive or corrosive cleaning detergents, as they can
damage the plastic parts of the appliance.
Cleaning agents and solvents such as gasoline, carbon tetrachloride, chlorinated cleaning
solvents, ammonia, and household detergents that contain ammonia can damage plastic
components.
STORAGE
Attention! Store the saw in a well-ventilated area in a dry, dust-free place.
Store only a working device; repair any faults before storage.
 Before storing the saw, put the guard on the cutting unit and remove the battery.
 Always keep the tool out of reach of children.
Store the battery and charger in a dry, cool place, indoors. Temperatures above or below
normal room temperature will reduce battery life.
Never store the battery in a discharged state. Allow the battery to cool and charge before
storing. When you store the appliance for an extended period of time without use, charge
the battery every month or every two months. This practice will extend the life of the
battery.
CLEAN GUIDE AND CHAIN
Check the condition of the guide and chain after every 5 hours of operation or more
frequently, depending on the operating conditions.
To do this, remove the chain from the guide and:
 remove the sawdust from the guide groove and the oil hole,
 lubricate the chain with chain lubrication oil.
Turn the guide from time to time to avoid partial wear.
27