Precautions; Requirements; Minimum Configuration; Rack Mounting Kit - Dell PowerConnect W-6000 Installationsanleitung

Precautions

CAUTION: Dangerous voltage in excess of 240VAC is always present while the Power Supply Module is plugged into an
electrical outlet. Remove all rings, jewelry, and other potentially conductive material before working with this product.
Never insert foreign objects into the chassis, the power supply, or any other component, even when the power supplies have
been turned off, unplugged, or removed.
Main power is fully disconnected from the W-6000 controller by unplugging all installed power supplies' power cords from
their outlets. For safety, verify the power outlets and plugs are in easy reach of the operator.
Do not handle electrical cables which are not insulated. This includes any network cables.
To minimize electrical hazard, keep water and other fluids away from the product.
Comply with electrical grounding standards during all phases of installation and operation of the product. Do not allow the W-
6000 controller chassis, network ports, power supplies, or mounting brackets to contact any device, cable, object, or person
attached to a different electrical ground. Also, never connect the device to external storm grounding sources.
Installation or removal of the chassis or any module must be performed in a static-free environment. The proper use of anti-
static body straps and mats is strongly recommended.
Modules must be kept in anti-static packaging when not installed in the chassis.
Do not ship/store this product near strong electro-magnetic, electrostatic, magnetic or radioactive fields.
Do not disassemble the chassis or any module. They have no internal user-serviceable parts. When service or repair is needed,
see "Contacting Support" on page

Requirements

Minimum Configuration

A Dell PowerConnect W-6000 Controller must include the following basic components:
One W-6000 controller chassis
One fan tray
One W-6000M3 Controller Module in Slot 0 (purchased separately)
At least two 400W power supplies
NOTE: The number of power supplies required depends on the number of W-6000M3 Controller Modules installed in the chassis
(see "Power Management" on page
The W-6000 controller is shipped with all required power supply and fan tray modules installed. Install the
chassis as described in this chapter, and then see the subsequent chapters in this manual for instructions on
installing each additional module.

Rack Mounting Kit

Using the included rack mounting kit, the W-6000 controller can be mounted in a standard 19-inch Telecom
network equipment rack. The rack mounting kit contains the following parts:
6-32 x 1/4" Phillips Head Screws (6x, included)
10 | Installing the Chassis
6.
25).
Dell PowerConnect W-6000 Controller | Installation Guide