HOMCOM 820-292V70 Montageanleitung Seite 4

1. Thermostat control knob (TEMPERATURE SETTING): Adjust to maintain room
temperature.
2. F l ame switch: Switches the flame and turns it on/off.
3. Heat i ng sett i ng: Press
4. Heating setting : Press
pressing first).
5. Flame dimmer control: Adjust to set flame intensity.
Overheating safety device
I f the heater stops work i ng, turn it off and check if the inlet or out l et is blocked. Unplug the
unit and wait at least 10 minutes, so the protection system can reset. If the heater still
does not work, contact customer service for inspection or repa i r.
Before restarting the heater, ensure it has been unplugged for at least 10 minutes.
Cleaning
1. Always unplug the unit before cleaning.
2. Clean the outside of the heater by wiping with a damp or dry cloth.
3. Do not use petro l eum or any other detergent or chem i cal solvent to clean the heater.
4. When the heater has not been used for a wh il e, store in a c l ean, dry place, away from
dust and d i rt.
Disposal
Environmental Protection
Waste e l ectr i cal production should not be d i sposed of w i th househo l d waste.
Please recycle where fac il it i es exist. Check w i th your local authority or reta il er for
recyc l ing advice .
for 1000W.
and together for 2000W (cannot operate without
4