AEG A51900GSW0 Benutzerinformation Seite 16

16
Installation
2. Slide the door off the pin (G). Unscrew
the pin (G) and install it on the oppo-
site side.
3. Unscrew the pivot pin (Z) of the hinge
(E) and the rear screw (Y) with a span-
ner of 10 mm and remove the closing
device (M). Take from the accessory
bag the lower closing device left and
install it on the opposite side of the
same hinge by screwing again the rear
screw.
4. Unscrew the upper closing device (N)
from the bottom of the door. Take
from the accessory bag the upper clos-
ing device left and install it on the opposite side of the bottom of the door by
screwing again the screw.
5. Install the door.
6. Install the bottom hinge (E) on the opposite side, using the three screws previously
removed inserting the hinge gasket (X).
7. Remove the blanking cover (F) from the ventilation grille (D) by pushing it in the
direction of the arrow and install it on the opposite side.
8. Install the ventilation grille (D), clipping it into place.
9. Unscrew the handle. Remove the plug
with a punch. Install the handle and
the plug on opposite side. Take from
the accessory bag the two plugs and
cover the holes left open after having
removed the handle.
10. Make sure that the front board of the
door is parallel to the front board of
the top.
11. Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the gasket.
G
180°