Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Disassembly and Maintenance
The floor broom and the roller brush
Battery disassembly
Press the battery release button,
grab the battery and pull it out
11
Install battery: Alignthebattery
slot with the card slot, press the
bottom to slide into the battery
slot until it snaps tightly.
Troubleshooting
Symptoms
Possible Causes
Cannot turn on
Low battery power.
No power supply to the
adaptor.
Fully charged
Wrong power adaptor is
but run for a few
used.
seconds only
Filter is clogged by fine
Weak suction
dust.
Machine stop
Motorised brush is not
Working with
spinning.
suction blockage
Air passage is clogged
indicator lit up
by foreign object.
Motor sounds
Vacuum inlet or filter is
abnormal
clogged.
when running
Main brush not
Brush is stuck.
spinning
Notes:If you have any questions regarding usage, please
feel free to contact us via the following email.
After-sales service:After-sales service:info@vistefly.com
Return service:Return service:returnsupport@vistefly.com
Suggested Solutions
Charge the unit to use.The power/
battery indicating lights should move
Ensure that the power socket is working.
Verify it with other appliance.
Check that you are using the correct
adaptor with output 35V/0.5A.
Clean filter regularly. Refer to Maintenance
section.
Remove hair and foreign object from the
brush.Remove compressed hair strains from
the bearing.Refer to Maintenance section.
Check and remove any foreign object at the
floor brush, extension rod, main body air inlet
and dirt bin.
Clear blockage along brush inlet, extension
rod and dirt bin, and clean filter.
Remove any foreign object that caused the
brush to cut off power automatically.
lf there is no foreign object (it may have
dropped off ), restart the vacuum.
12
Werbung
