Care And Cleaning; What To Do If - IKEA FRAMTID HGA2K Bedienungsanleitung

ENGLISH

Care and cleaning

Warning! Switch the appliance off and
let it cool down before you clean it.
Warning! For safety reasons, do not
clean the appliance with steam blasters
or high-pressure cleaners.
Warning! Do not use abrasive cleaners,
steel wool pads or acids, they will
damage the appliance.
To remove any food remains wash the enam-
elled elements, "caps" and "crowns", with
warm soapy water.
Stainless steel elements wash with water, and
then dry with a soft cloth.

What to do if...

Problem
There is no spark when light-
ing the gas
The flame is blowing out im-
mediately after lightning
The gas ring burns unevenly
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a sol-
ution to the problem yourself, contact your
dealer or the After Sales Service.
This model is equipped with electrical igni-
tion, it is obtained through ceramic "candle"
and electrode.
Keep them well clean to avoid difficult light-
ning.
ply pipe and the pressure adjuster, if it is fit-
ted (this service is not free of charge).
After cleaning, be sure to wipe dry with a soft
cloth.
Possible cause
There is no electrical supply
Burner cap and Crown are
placed uneven
Thermocouple is not heated
enough
Burner crown is blocked with
food residues
a registered engineer, the visit from the cus-
tomer service technician or dealer may not
take place free of charge, even during the
warranty period.
Periodically ask your local Service Cen-
tre to check the conditions of the gas sup-
Check that the unit is plug-
ged in and the electrical sup-
ply is switched on.
Check the house electric in-
stallation fuse.
Check the burner cap and
crown have been replaced
correctly, e.g. after cleaning.
After lightning the flame,
keep the knob pushed for
about 5 sec.
Check the main injector is not
blocked and the burner
crown is clear of food parti-
cles.
If you operated the appliance wrongly,
or the installation was not carried out by
Remedy
7