Notes On Troubleshooting - Rehau Rautool G2 Bedienungsanleitung

RAUTOOL G2

nOTes On TROUBLesHOOTinG

for operation with battery
Defect Cause
Motor does not run - Tool/Battery contacts dirty
- Tool/Battery contacts damaged
- Battery not locked correctly into the tool.
- Battery empty.
- Battery faulty
Battery does not charge - Charger not plugged in correctly
- No power coming to socket
- Charger / Mains cable or plug damaged
- Charger not ready
- Charger/Battery contacts dirty
- Charger/Battery contacts damaged
- Battery not locked into charger correctly
for operation with power adapter
Defect Cause
Motor does not run - Tool/Mains adapter contacts dirty
- Tool/Mains adapter contacts damaged
- Mains adapter not correctly locked into tool
- Mains adapter not plugged in correctly
- No power coming to socket
- Mains adapter / Mains cable or plug damaged
- Mains adapter overheated
General
Defect Cause
Motor does not run - Control cable not inserted correctly
- Control cable / Pressure switch faulty
- Tool faulty
Motor runs, but working - Leak in hydraulic hose
unit not does function or (Attention: Only inspect at zero pressure!)
only partially
Tool does not reach - Leak in hydraulic hose
final pressure (Attention: Only inspect at zero pressure!)
- Tool faulty
If the defects cannot be remedied, return the tool to the reHAU service center or your dealer .
32
All manuals and user guides at all-guides.com
Correction
Clean contacts when dry with non-conducting material
Send tool/battery to REHAU service center
Reinsert battery, pay attention to locking mechanism!
Charge battery
Send battery to REHAU service center or independently
give to the recycling system
Reinsert mains plug
Change socket
Send charger to REHAU service center
Wait for green LED to flash
Clean contacts when dry with non-conducting material
Send charger/battery to REHAU service center
Reinsert battery, pay attention to locking mechanism!
Correction
Clean contacts when dry with non-conducting material
Send tool/mains adapter to REHAU service center
Plug in mains adapter again, pay attention to locking mechanism!
Reinsert mains plug
Change socket
Send mains adapter to REHAU service center.
Allow mains adapter to cool down
Correction
Insert control cable properly
Send working unit to REHAU service center
Send power unit to REHAU service center
Send working unit to REHAU service center
Send working unit to REHAU service center
Send unit to REHAU service center