Crivit CFMK 7 A1 Originalbetriebsanleitung Seite 17

z Using the mini bike compressor
Presta valve:
Remove the cap of the Presta valve.
„
Unscrew the valve of on the knurled screw slightly, in order to allow some
„
airflow.
With the valve adapter for Presta valves
„
compressor
Schrader valve:
Remove the cap of the Schrader valve.
„
With the valve adapter for Schrader valves
„
compressor
Switch the mini bike compressor
„
the compressor
As soon as approx. 3 bar is reached for Schrader valve adapters
„
7 bar for Presta valve adapters
valve will release air.
Switch the mini bike compressor
„
the compressor
Proceed as described above in reverse order, to disconnect the mini bike
„
compressor
ATTENTION: Use the mini bike compressor
valve adapters only on tyres, which are suitable for the pressure range which
is stated on the valve adapters. Excessive pressure can damage tyres or
cause dangerous accidents.
PLEASE NOTE: When disconnecting the mini bike compressor
the valve, air may escape from the valve. So make sure you disconnect the
device from the valve as quickly as possible. Air can also can escape from
the valve if the valve adapter is fitted at an angle.
ATTENTION: During operation, the compressed air outlet and the valve
adapter of the mini bike compressor which is connected to it
hot. Make sure that you do not come into contact with it during operation to
avoid suffering burns. At the end of the job, wait for at least 10 minutes
before you disconnect the valve adapter from the mini bike compressor
onto the valve so that it is firmly in place and level.
1
onto the valve so that it is firmly in place and level.
1
.
2
again.
2
from the respective valve and closing off that valve.
1
fitted, put the mini bike
7
fitted, put the mini bike
6
on by pressing the On/Off button of
1
, then the integrated pressure relief
7
off by pressing the On/Off button of
1
1
GB/IE/NI/CY/MT
with the appropriate
will become
1
or
6
from
1
.
1
17