HOMCOM Hs93363 Bedienungsanleitung Seite 4

EN
2. Heater switch 2
When the unit is on, press 'Heater switch 2' to heat at 1000W.
3. Heater switch 3
When the unit is on, press 'Heater switch 3' to heat at 2000W.
4. Brightness button
Press the 'T button' on the control panel to change the fuel bed and flame brightness.
There are four settings: The default setting is the lightest. Every time you click the
brightness button, it will get dimmer. When it is darkest, it will automatically be the
lightest.
5. Thermostat control knob (TEMPERATURE SETTING): Adjust to maintain room
temperature.
Note: For the heater to operate, set the thermostat higher than the current room
temperature.
Assembly Instructions
Portable Installation Method: Figure 1
1. Ensure the heater is switched off and unplugged, then
turn the heater upside down.
2. Remove the screws from its original hole, then align
the mounting holes on the foot with the mounting
holes on the heater body.
3. Insert the three screws and tighten.
4. Repeat these steps for the other feet.
Overheating safety device
If the heater stops working, turn it off and check if the inlet or outlet is blocked. Unplug
the unit and wait at least 15 minutes, so the protection system can reset. If the heater
still does not work, contact customer service for inspection or repair.
Before restarting the heater, ensure it has been unplugged for at least 15 minutes.
Cleaning
1. Always unplug the unit before cleaning.
2. Clean the outside of the heater by wiping with a damp or dry cloth.
3. Do not use petroleum or any other detergent or chemical solvent to clean the heater.
4. When the heater has not been used for a while, store in a clean, dry place, away from
dust and dirt.
Disposal
Environmental Protection
Waste electrical production should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer
for recycling advice.
4
Figure 1