Bosch MCM64080 Gebrauchsanleitung Seite 19

Insert the dicer.

The arrow on the dicer and the arrow
on the bowl must be in alignment!
Dicer must be positioned fully on the drive
shaft! If required, turn the blade insert into
the correct position using the blade cover
(Fig. -6).

Remove the blade cover.

Attach lid (match arrow on lid on dot on

bowl) and rotate in a clockwise direction.
Lid lug must be located fully in the slot
in the bowl handle.
Insert pusher and pusher insert.

Insert the mains plug.

Set the rotary switch to the desired

setting.
Place the food to be diced in the feed

tube. If required, apply light pressure
to the pusher. If required, chop up food
beforehand.
Warning!
Empty the bowl without delay:
– after processing 500 g,
– before the cubes have reached the lower
edge of the dicer.
After using the appliance
Set the rotary switch to 0/off.

Remove mains plug.

Rotate the lid in an anti-clockwise

direction and remove.
Attach the blade cover.

Take dicer out of the bowl.

Rotate the bowl in an anti-clockwise

direction and remove.
Remove the drive shaft.

Remove food remnants from the cutting

grid using the cutting grid cleaner.
Blender
for mixing liquid or semi-solid food,
for cutting/chopping raw fruit and
vegetables, for puréeing food.
A blender can be ordered from
customer service (order no. 743882).
Risk of injury from sharp blades/
rotating drive!
Never place fingers in the attached
blender!
Blender will not operate until the lid has
been screwed on tight. Do not remove
the blender until the drive is at a standstill.
Robert Bosch Hausgeräte GmbH
Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid.
Add a max. 0,4 litres of hot or frothing
liquid.
Warning!
Blender may be damaged. Do not process
deep-frozen ingredients (except ice cubes).
Do not operate blender when empty.
Blending
Warning!
To operate the blender, the blender lid must
be attached and screwed on tightly.
Fig.

Attach the blender jug (match arrow

on the jug to the arrow on the appliance)
and rotate as far as possible in a clock-
wise direction.
Add ingredients.

Maximum capacity, liquid = 1.5 litres
(frothing or hot liquids max. 0.4 litres).
Optimal processing capacity – solids
= 80 g.
Attach lid and rotate in a clockwise

direction. Lid lug must be located
fully in the slot in the blender handle.
Set the rotary switch to the desired

setting.
To add more ingredients, set the rotary

switch to 0/off.
Remove the lid and add ingredients

or
remove the funnel and gradually add

solid ingredients through the refill
opening
or
pour liquid ingredients through the funnel.

After blending
Set the rotary switch to 0/off.

Remove mains plug.

Rotate the blender in an anti-clockwise

direction and remove.
Rotate the lid in an anti-clockwise

direction and remove.
Tip: It is recommended to clean the blender
immediately after use see "Cleaning and
servicing".
en
19