Timago TGR-R WA C2600 Benutzerhandbuch Seite 36

On comple�on of the above ac�vi�es, the wheelchair is ready to use.
FOLDING
The wheelchair can be re-folded in order to be transported and stored more
easily.
• Swing away the footplates and set them in ver�cal posi�on (perpendicularly
to the ground).
• Grab the cushion and upholstery and detach from Velcro.
• To fold the frame, pull the seat upwards by holding the front and the back
edge in the middle, so that the frame jumps out from the connec�ng
elements.
• If necessary, li� the an�-�pping wheels to the maximum height.
FLIP-UP FUNCTION OF ARMRESTS
• Press the locking buton located in the front part of the armrest and push
the armrest backwards.
• To close the armrest, push it downwards so that the locking buton clicks.
PUMPING THE WHEELS
• The wheelchair was equipped with pneuma�c rear wheels 22'' in diameter
and swivel, PU front wheels 6'' in diameter (tubeless tyre). Remember to
control the air pressure in both wheels and check the condi�on of the tyres
in search of abrasions, cuts or surface deple�on.
• To balance the air pressure in the wheels, twist off the cap of the valve,
insert the pump (included in the set) into the valve, and pump the air.
WHEEL LOCKS
• To lock the wheels, push the wheel lock lever forwards un�l the wheel is
fully blocked (separately for le� and right wheel). Please, note that the
wheel lock only serves to lock the wheels when the wheelchair is at a
complete stop.
WHEEL LOCKS ADJUSTMENT
The correct lock of the wheel lock depends on its adjustment and posi�on. The
handle of the wheel lock should be posi�oned so that the wheel lock shoe blocks
the wheel firmly and the lever does not face excessive resistance.
36