K&H 5Z-KHG Gebrauchsanleitung Seite 30

After you have converted the cooktop to another gas type, make sure you have placed a
label containing that information on the appliance.
8 TABLE 2: HOW TO CONVERT GAS SOURCE
Adjustment of the reduced valve flow
Burners Flame
Full flame
Regular burners
Saving flame
Valve adjustment
Valve adjustment should be done with the control knob set at Burner ON saving flame position.
Remove the knob, and adjust the flame with a tiny screwdriver (see fig.7 below).
Checking the adjusted flame: heat the burner at full open position for 10 minutes. The turn the
knob into the saving setting. The flame should not extinguish nor move to the nozzle. If it goes off
or moves over to the nozzle, readjust the valves.
Replacement of burner nozzle: loosen the nozzle with a
dedicated wrench(7).Fit the new nozzle, suitable for the required gas
type (see table above for reference)。
Converting the
cooktop from LPG
to natural gas
Replace the burner
Nozzle according
To the guidelines in
table 1
Loosen the adjustment
Spindle (see fig.7 below )
And adjust the flame
Fig.7
30
Converting the
Cooktop from natural
Gas to LPG
Replace the burner
Nozzle according
to the guidelines in
table 1
Loosen the adjustment
Spindle (see fig.7 below )
And adjust the flame