ACD R3 ALULINE Bedienungsanleitung Seite 26

Page 11 Glazing the Façades
The standard façades are equipped with clear glass. 2 pieces of glass are placed on top of one another with a glass strip, putting the smallest side
at the outside. Put the rubbers in place as soon as possible!!! For each glass pane!!! Do so for both façades.
Do not put rubber around the door position.
Page 12 Door
Open the iron work bag. The numbers of the detailed views indicate the assembly order. Tighten the assembly definitively.
Page 13 Door
The wheels on top of the door do not have a washer; at the bottom, the wheels have a washer, as indicated on the detailed views.
The wheels are tightened by screwing them at 5cm from the side.
Page 14 Door
Silicone is used on both assembly profiles and over the full length. The silicone keeps the profiles from sliding.
Slide the door on both assembly profiles. Then place the glass in the door and put the rubbers in place.
Page 15 Door
Install the door stop on the inside, at the bottom of the vertical door profile.
Page 16 Cross beam
Open the roof window iron work bag. The numbers of the detailed views indicate the assembly order. Tighten the assembly definitively.
Install the elongated plates with the bulge in the bolt slot of the crossbeam.
Page 17 Roof window
The numbers of the detailed views indicate the assembly order. Put the rubbers of the profiles in place after installation of the glass.
Page 18 Roof window
Install the glass on top of the sidewall and slide it upward between the roof profiles until it does not rest on the sidewall anymore. Pull the glass
downward in the provided slot. Press the crossbeam until it closely fits the underlying glass and assemble it definitively with the special assembly
bolts.
Put the rubbers in place on the two roof profiles, in the same way as you did for the rest of the roof.
Also put the rubber on the crossbeam, cut off the rubber diagonally so that it closely fits.
Press a piece of rubber in the round hole of the ridge to avoid the roof window from sliding.
To open the roof window, slide the round bar on the curl in the roof window and on the bolt in the crossbeam.
If the roof window is not open, the round bar is put on the support.
P