Xblitz iGO Bedienungsanleitung Seite 17

noises. The recorded sounds may overlap. Windscreen air vents can also
distort the sound.
7. The device does not respond
Press the Reset button briefly or return the device to factory settings.
8. Transverse stripes are present in the footage
Incorrect setting of the frame rate value. Set the frequency value to
"50Hz" or "60Hz" depending on local settings.
9. Handle detaches from windshield/does not stick
Degrease the surfaces well before mounting the holder on the glass.
Remember to avoid high temperatures, which can cause deformation of
the holder, and damage to the recorder itself.
NOTES:
- G-SENSOR - a function thanks to which recordings with recorded
overloads (e.g. uneven road surface, braking, driving off a kerb or over a
speed bump, etc.) are protected from being overwritten. If you use this
function, you must periodically format the memory card on your com-
puter and then on the camera. Ultimately, each file on the data carrier
will be protected from being overwritten and the device will not be able
to record a further route - it will not record in a loop. We suggest setting
the sensor according to your driving style and road conditions. The op-
tion can also be completely disabled, in which case each oldest file will
be overwritten and the card will not need to be formatted periodically.
- PARKING MODE/MONITOR - a function designed to operate while the
vehicle is parked, uses battery power* if the camera is fully charged - (*if
it has a built-in battery). In this case, the camera starts recording a few
seconds of video after detecting a shock - until the battery is discharged.
When using this function, bear in mind the battery of the device,
which needs to be charged after the function is activated (started). You
should deactivate the function, before setting off on a journey, as it may
cause the camera to switch on and off and make random fragments of
recordings from the route.
The operation of the vehicle's constant power supply can cause this
function to behave differently, e.g. leaving the camera on, which can
drain the car's battery.
- MOVEMENT DETECTION - a function designed to operate while the
vehicle is parked - requires constant power and the camera must remain
switched on. The camera will start recording automatically when motion
is detected, and will stop recording a few seconds after there is no
movement in front of the camera lens. Please note that this function can
drain the car battery.
17