Care And Maintenance - Homcom 820-282V90 Bedienungsanleitung

EN
SETTING THERMOSTAT: After heater has been turned on and the room has reached
the desired temperature, slowly rotate the thermostat knob counter-clockwise until
the heater shuts off (you should hear a faint "click") By leaving the thermostat at the
setting it will automatically maintain this temperature. To lower the temperature,
rotate the knob further counter-clockwise towards the LOW(-) position. To raise the
temperature, rotate the thermostat knob clockwise towards the HIGH(+) position.
TURNING OFF: Turn the Main Power On/Off power switch OFF to discontinue use.
The Low Heat Switch and High Heat Switch can remain in any position and will have
no power. They will continue to have the same set functions when the heater is turned
back on. Heater should be unplugged when not in use.
IMPORTANT SAFETY FEATURES
The heater is equipped with an automatic overheat protection device located inside
the body of the heater. If the heater grille is obstructed, or if the heater gets too hot for
any reason, the automatic overheat protection device will turn the heater off. To reset
the heater, simply turn power off and unplug the heater for 10 minutes until it cools
down and you may plug the heater in and restart the heater. Be sure that the heater is
on a smooth level surface with no obstructions.

CARE AND MAINTENANCE

CLEANING: CAUTION-Before cleaning the heater be sure to disconnect power cord
and allow the heater to cool completely. Clean the outside surface with a clean damp
cloth. Do not use harsh chemical or abrasive cleaners. DO NOT IMMERSE THE
HEATER IN WATER. Allow heater to dry completely before use. Use a vacuum or
duster to keep heat and vent area clean and free of dust and dirt.
LEG ASSEMBLY:
Simple assembly is required if the legs of your heater arrive unassembled Using a
screwdriver, thread three screws through the holes in each leg as illustrated in Fig.1
below and tighten them down counter-clockwise onto the underside of the heater.
Please note: extra screws are provided, you may have some left over after assembly.
The bottom foot is placed at the bottom
of the product package.
Screw bag is put in the same bag as
instruction manual, do not discard
4