Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Overview of the device
Quick Start Guide
Illustration A
Connecting the spray/suction hose to the de-
1
vice, connecting the spray/suction hose to the
handle
Mixing cleaning solution, filling fresh water
2
tank
Selecting operating modes
3
Cleaning
4
Emptying the fresh water tank
5
Emptying the wastewater container
6
Filling the fresh water tank(without detergent),
7
rinsing the device
Cleaning the fluff filter, cleaning the fresh water
8
filter
Allowing the device to dry
9
Description of the device
Illustration B
Upholstery nozzle
1
Holder for accessories
2
Type plate
3
Mains cable
4
Hook for spray/suction hose or cable hook
5
Spray switch
6
Suction switch
7
Casing
8
Steering roller
9
Spray hose connection
10
Suction hose connection
11
Cover
12
Fresh water tank
13
Device carrying handle
14
Handle
15
Nozzle mouthpiece
16
Union nut
17
Handle lever
18
Spray hose
19
Suction hose
20
Spray / suction hose
21
Quick Start Guide
22
Wastewater container, removable
23
Wastewater container carrying handle
24
Cover seal
25
14
Fluff filter
26
Fresh water filter
27
1. Check the power cord, extension cable and
hoses for damage before each start-up.
Installing accessories
1. Fit the upholstery nozzle onto the handle and
hand-tighten the union nut on the handle.
2. Connect the suction hose to the suction hose
connection on the device. Insert the spray hose
coupling into the spray hose connection on the
device and latch into place.
3. Connect the suction hose to the handle. Con-
nect the spray hose coupling to the handle and
latch into place.
Mixing the cleaning solution
DANGER
Danger from detergents
Risk of injury and damage
Observe all instructions that are included
with the detergents used.
Note
Warm water (maximum 50 °C) increases the
cleaning effect. Check the temperature resistance
of the surface to be cleaned.
Note
Use detergents sparingly to conserve the environ-
ment.
1. Mix fresh water and detergent in a clean con-
tainer (concentration as specified for the deter-
gent). Dissolve the detergent in the water.
Filling the fresh water tank
1. Pour the cleaning solution into the fresh water
tank. The filling level must not exceed the
"MAX" mark.
Defoaming agent
Note
Foam is generated in the wastewater container
when cleaning previously shampooed carpets.
Foaming can be prevented by adding defoaming
agents.
1. Add defoaming agent (special accessory) to
the wastewater container.
English
Start-up
Werbung
