Ruris RTX800 Bedienungsanleitung Seite 30

EN
9.2 Troubleshooting
Problem
Cutter does not
start
The disc spins
at idle
The disc does
not rotate in
the while the
engine is
accelerating
The cutter has
no power then
When It is
accelerated
Vibration
levels _ are
too big
The
temperature
cutter is too
high
14
CAUSE pOSSIBLE
started steps unsound
The switch is not switched in the ON
position
The cutter is out of fuel
The spark plug is fouled and
Presents oil deposits
High idle speed
Defective clutch
belt too low or bad
Defective clutch
disc It is mounted incorrect
Air filter clogged
Fuel filter clogged
hole the fuel tank is blocked
Disc mounted incorrect
Defective disc
Vibration damping elements faults
grids to be admitted air are
blocked
belt glide
clutch slips / is defective
Method SOLVING
REVIEW chapter ' Start '
Toggle the switch to
ON position
Load cutter
The spark plug is cleaned with a brush or is
replaced
Adjust rev
Contact an authorized RURIS service
Squeeze or Substitutes belt
Contact an authorized RURIS service
adapt your DISC correct
Check the air filter and replace it if
It is necessary
Substitutes the fuel filter
Contact an authorized RURIS service
Check if the cutting disc is mounted correct
and does not present signs of damage .
Change DISC
Contact an authorized RURIS service
Clean air intake / cooling grilles of the
cutter
Check the belt / tighten it if It is necessary
Check belt / tension it if necessary