Maintenance And Troubleshooting - Ruris Rtx800 Bedienungsanleitung

EN
Switching
1.Make sure the ON/OFF switch is in the ON(I) position, the start
position.
2. Actuate the shock lever and the shock flap will close
3. Press the decompression valve to reduce the pressure in the cylinder. The relief
valve should always be used when starting, it automatically returns to its original
position when the cutter starts.
3. Constantly press the priming pump until it fills with fuel and
returns to the tank (about 6 times).
4. Place the cutter on a solid flat surface. Insert your right
foot into the sole of the cutter and with your left hand firmly grasp the
handling handle.
CAREFUL! Make sure that the disc does not come into contact with
foreign bodies or other objects when starting. With your right hand pull
gently until you feel resistance and the starter rope is taut, then in one
motion pull steadily. Do not let go of the handle, but bring it back to its
initial position with your hand. Repeat the operation on the cutter
starter until you hear the first start sign. At this point stop operating the
starter. Push the shock back to its original position. Repeat the starter
actuation in the same manner until the cutter starts to accelerate. After a few seconds, operate the
throttle briefly to stabilize the idle.
When the engine is warm, the shock lever and the priming pump are no longer actuated.
To stop the engine, turn the ON/OFF switch to the OFF(0) position, the stop position.
The images are informative, the supplier reserves the right to make structural and functional
changes to the machine presented in this manual.

9. MAINTENANCE AND TROUBLESHOOTING

9.1 Maintenance
Exterior Cleaning - Clean the machine daily using a clean cloth after work is done.
11