Ruris RTX800 Bedienungsanleitung Seite 21

EN
Throttle lock
The throttle lock is designed to prevent accidental throttle operation.
When the lock (A) is pressed, it releases the throttle lever (B), it can be
pressed,
Make sure the throttle lever is locked when the throttle lock is released.
Press the throttle lock and make sure it returns to its original position
after you release it.
Make sure the detent and throttle lever move freely and return to their
original position after being released.
Start the cutter and accelerate it to full speed. Release the throttle lever
and check that the cutting disc stops. If the cutting blade spins when the
throttle is released, you need to adjust the carburetor for idle.
ON/OFF switch
Make sure the cutter motor stops when you turn
the switch to the OFF position.
Blade guard
This guard is mounted above the cutting blade and is designed to
protect the user from fragments of the blade that may be thrown at
them, should the blade break while using the cutter.
Check that the guard above the cutting blade is not cracked or
damaged. Replace if damaged. Check that the cutting blade is
correctly mounted and shows no signs of damage. A damaged
cutting blade can cause personal injury.
Vibration dampening system
The cutter is equipped with a vibration dampening system that
is designed to reduce vibration and ease of use. The
machine's vibration damping system reduces the transfer of
vibration between the motor unit/cutting equipment and the
cutter handle. The motor body, including the cutting
equipment, is isolated from the handles by vibration damping
units.
Check the vibration damping units regularly for deformation or cracks. Replace them if they are
damaged. Check that the vibration damping element is securely fastened.
Careful!
• A cutting disc may break and cause injury to the operator.
• The manufacturer of the cutting disc issues warnings and recommendations for its proper use.
• A cutting disc should be checked before it is assembled on the cutter and periodically during use. Make
sure it has no cracks, missing segments or broken pieces. Do not use a damaged cutting disc. Test the
integrity of each new cutting disc by running it idle at full throttle for about 1 minute.
Cutting discs
Diamond discs consist of a steel core fitted with segments containing
industrial diamonds. When using a diamond blade, make sure it is properly
mounted on the cutter and that it rotates in the direction indicated by the
arrow on the blade.
When replacing the cutting disc, make sure that its technical specifications
correspond to the specifications of the cutter.
5