Ruris RTX800 Bedienungsanleitung Seite 25

EN
• Keep a safe distance from the cutting disc when the engine is running.
• Never leave the mower unattended with the engine running.
• Make sure the disc has come to a complete stop before putting the cutter
down.
• The cutter guard must be adjusted so that the back is flush with the
workpiece. Dust and sparks from the cut material are collected and thrown
away from the user.
• Maintain good balance and a firm posture while working.
• Never cut above shoulder height.
• Never cut from a ladder. Use a platform or scaffold if the cut is above
shoulder height.
• Stand a safe distance from the workpiece. Make sure the blade does not
come into contact with other objects when starting the cutter.
• Start cutting only after the blade has reached maximum speed. Do not
apply pressure to the cutting disc, let the cutter work without forcing or
putting pressure on the disc. Maintain full speed until cutting is complete.
• Move the blade slowly back and forth to obtain a small contact area between the blade and the material
to be cut. This reduces the temperature of the disc and ensures efficient cutting.
Dust resulting from cutting
• The cutter is equipped with a low-pressure disc cooling system that provides maximum suppression of
dust resulting from cutting.
• Use water-cooled cutting discs when possible to reduce dust.
• Adjust the water flow to capture the dust resulting from cutting. The amount of water required varies
depending on the type of material being cut.
Disc jamming during cutting
Make a careful assessment of how the object will move during the final stage of the cut to avoid snagging
or jamming. If the object is dropped and the cut begins to close, the disc may jam, resulting in kickback or
damage to the disc.
9