Ruris RTX800 Bedienungsanleitung Seite 28

EN
Cooling Air Intake - Clean the cooling air intake when necessary.
spark
If the cutter has low power, starts hard, or idles poorly, check the
spark plug first.
Make sure the spark plug plug is not damaged.
If the spark plug is dirty, clean it and at the same time check that the
gap between the electrodes is 0.5 mm.
Tensioning the transmission belt
The drive belt is enclosed and well protected from dust and dirt.
Loosen the three screws (A) by turning them one turn
counterclockwise.
Move the disc guard (E) up and down 3-5 times, then tighten the nuts (A)
Replacing the transmission belt
1. Loosen the three nuts (A) securing the upper belt guard. Turn the
belt tensioner (B) to the "O" position to loosen the belt.
12