Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
R E M OT E C O N T R O L
The remote control can be used to control
any of the fan's functions from a distance.
The remote must be within 5 m / 16 ft of
the fan to work.
Note:
•
Remove the plastic tab from the remote
control's battery compartment before using.
•
To replace the battery, see page 12.
Sound/Display Off Button
•
Press to turn selection sounds
and display on/off.
Fan Mode Button
•
Press to cycle through fan
modes: Normal, Turbo, ECO and
Sleep (see Fan Modes, page 10).
G E T T I N G S TA R T E D
WARNING: Do not
1.
Remove all packaging.
2. Rotate the pole clockwise to attach it to
the base. Rotate the fan head clockwise
onto the pole. [Figure 2.1]
3. Optionally, you can attach the fan head
directly to the base for a shorter fan.
[Figure 2.2]
4. Place the fan on a flat, stable surface
such as the floor.
P E D E S TA L FA N P L AC E M E N T
•
Point the fan towards the ceiling to
circulate the air in the room. [Figure 3.1]
•
Point the fan forward to circulate cool
air when the air conditioner is on.
[Figure 3.2]
•
Point the fan out a door or window
to circulate fresh air from outside.
[Figure 3.3]
8
use the fan before finishing assembly.
Increase/
Decrease
Fan Speed
Buttons
Fan Mode
Button
Sound/Display
Off Button
5. Insert the power adapter into the port,
located at the bottom of the fan. Plug in
and turn on. [Figure 2.3]
6. When using the fan, allow at least
38 cm / 15 inches of clearance from
the front of the fan. Keep away from
anything that would block air flow, such
as curtains. [Figure 2.4]
•
Point the fan upwards to circulate warm
air when the heater is on. [Figure 3.4]
•
Point the fan towards wet laundry to
expedite drying. [Figure 3.5]
Left/Right
Oscillate
Button
Up/Down
Oscillate
Button
Timer
Button
Power
Button
Werbung
