Automatic Time Setting; Manual Time Setting - National Geographic Va Colour Rc Bedienungsanleitung

2. Insert the Euro plug into the mains power socket.
3. The device is powered on directly.
4. Wait until indoor temperature is displayed on the base unit.
NOTICE! For permanent operation, mains power supply is recommended. Alternatively, op-
eration using batteries is also possible to maintain the time setting in the event of a power
failure. In battery operation, the station is set to power saving mode after 6 seconds and the
display indication is deactivated. The display can be reactivated by pressing the snooze but-
ton.
For battery operation, proceed as follows:
5. Remove the battery compartment cover.
6. Insert batteries into the battery compartment. Make sure that the batteries are correctly aligned
(+/- poles).
7. Replace the battery compartment cover.
8. Wait until indoor temperature is displayed on the base unit.
NOTICE! When changing the type of power supply (mains power or batteries), the power
supply is temporarily interrupted for technical reasons. All previously made settings will be
lost.
Wireless sensor
9. Remove the battery compartment cover.
10. Insert batteries into the battery compartment. Make sure that the batteries are correctly aligned
(+/- poles).
11. Move the channel slider to the desired channel.
NOTICE! This weather station can be operated with one or more wireless sensors. Each con-
nected wireless sensor must be operated on a different channel. If only one wireless sensor is
connected, it should be operated on channel 1.
12. Replace the battery compartment cover.

11 Automatic time setting

After the power is restored, the unit automatically searches for the radio signal. It takes approximately
3-8 minutes for this process to complete.
If the radio signal is received correctly, the date and time are set automatically and the reception sym-
bol is displayed.
NOTICE! Some functions/buttons are deactivated during radio signal reception.
If no radio signal is received, proceed as follows:
1. Press the UP button on the base unit for approx. 3 seconds to activate reception of the radio sig-
nal. Reception is now initialized again.
2. If still no radio signal is received, the time must be set manually.

12 Manual time setting

To set the time/date manually, first check whether the radio symbol in the display is still flashing (auto-
matic reception of the time signal is then still active). Now press the UP button for approx. 3 seconds
to deactivate reception.
1. Press the SET button for approx. 3 seconds to enter the time setting mode.
2. Digits to be set are flashing.
3. Press UP or DOWN button to change the value.
4. Press the SET button to confirm and switch to the next setting.
23 / 56