Pattfield Ergo Tools PE-RB 400 Originalbetriebsanleitung Seite 131

Regenfasspumpe 400w

Verfügbare Sprachen

equipment switches on and off.

•

Make sure that the distance between the floating switch head and

the cable holder is not too smaller than 10 cm. If the distance is

too small, there is no guarantee that the equipment will work cor-

rectly.

•

When adjusting the floating switch, make sure that the floating

switch does not touch the bottom before the equipment is swit-

ched off. Important! Risk of dry running.

Manual operation:

For manual operation place the lock for the ﬂ oat switch (5) on the

straight pipe piece (6) Fig. 5).

Mount the ﬂ oating switch as illustrated in Fig. 5. The equipment will

then run continuously. To prevent dry running, this operating mode is

allowed only under supervision. The equipment must be switched oﬀ

(pull out the power plug) as soon as no more water is emitted from

the discharge line.

7. Replacing the power cable

Danger!

If the power cable for this equipment is damaged, it must be replaced

by the manufacturer or its after-sales service or similarly trained per-

sonnel to avoid danger.

8. Cleaning, maintenance and ordering of spare parts

Danger!

•

Unplug the power plug prior to any maintenance work.

•

For mobile applications, the equipment should be cleaned with

clear water after every usage.

•

For stationary installation, it is recommended that you check the

floating switch for proper operation every three months.

•

Use a water jet to remove any lint or fibrous particles that may

Anl_PE_RB_400_SPK7.indb 131

- 131 -

06.03.2025 08:34:12