Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Examples of such safety measures:
Pumps running in parallel on a separately protected power circuit,
moisture sensors for switching off the pumps, and similar safety ar-
rangements.
Be sure to consult a professional plumber if you have any doubt.
The maximum pumping rate is possible only with the largest possible
line diameter; if smaller hoses or pipes are connected, the pumping
rate will be reduced.
When installing, never hang the equipment by the discharge line or
by the power cable. The equipment must be hung on the rain barrel
with the help of the pipe set or it must rest on the bottom of the shaft.
To ensure that the equipment works properly, the bottom of the shaft
always must be free of sludge and other accumulations of dirt. If the
water level is too low, the sludge in the shaft can quickly dry out and
hinder the equipment from starting. It is necessary therefore to check
the equipment regularly (carry out trial start-ups).
The pump shaft should be large enough.
5.2 Using the pump in the rain barrel
Fit the supplied pipe set as described and make sure that the seals
between the individual components are correctly seated (Fig. 3):
1. Connect the straight pipe piece (6) to the pipe bend (7).
2. Screw the complete pipe set to the pressure connector (4) of the
pump.
Proceed as follows to use the pump in the rain barrel:
•
Connect the pipe set to the pump.
•
Use the pipe bend (Fig. 3 / Item A) to hang the pump in a rain bar-
rel.
•
If necessary, use a hose to extend the telescopic pipe.
•
To withdraw water, open the stopcock (Fig. 3 / Item B).
Anl_PE_RB_400_SPK7.indb 129
Anl_PE_RB_400_SPK7.indb 129
- 129 -
GB
06.03.2025 08:34:10
06.03.2025 08:34:10
Werbung
