Technical Specifications; Power Supply; Signal Outputs - Musway M10 Bedienungsanleitung

Vorschau ausblenden

Inhalt

Seite von 33

/ 33
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

ENGLISH

TECHNICAL SPECIFICATIONS

POWER SUPPLY

Voltage:

7.6 - 17.3 VDC

Idle Current:

2.0 A

Switched off:

< 0.1 mA

Remote IN:

7,5 - 15 VDC (1 mA)

Remote OUT:

11 - 15 VDC (200 mA)

Internal Fuse on the PC board:

40 A x 2

AMPLIFIER STAGE

Distortion - THD, 1 kHz @ 4 Ω, 10 W:

0.01 %

Bandwidth -3 dB, 2 V(RMS, 4 Ω:

5 Hz - 22 kHz

S/N ratio @ A weighted, 1 V, Max. Power:

95 dB A

Damping factor @ 1 kHz, 2 V/RMS, 4 Ω:

> 100

Input Sensitivity:

CH 1-8: 8 - 24 V/RMS (high-level)

CH 9-10: 8 - 32 V/RMS (high-level)

2 - 6 V/RMS (low-level)

1 - 8 V/RMS (AUX)

Input Impedance:

13 Ω (high-level)

47 kΩ (AUX, low-level)

Output Power @ 13,8 VDC, 1% THD:

8 x 155 Watts RMS @ 2 Ω (Channel 1 - 8 DHR*) +

2 x 220 Watts RMS @ 2 Ω (Channel 9 / 10)

8 x 80/135 Watts RMS @ 4/2 Ω (Channel 1 - 8) +

2 x 120/220 Watts RMS @ 4/2 Ω (Channel 9 / 10)

Output Power bridged @ 13,8 VDC, 1% THD:

4 x 310 Watts RMS @ 4 Ω (Channel - 8 DHR*) +

1 x 440 Watts RMS @ 4 Ω (Channel 9 / 10)

4 x 270 Watts RMS @ 4 Ω (Channel 1 - 8) +

1 x 440 Watts RMS @ 4 Ω (Channel 9 / 10)

* Musway multi-channel amplifiers use innovative "Dynamic Headroom" (DHR) technology to achieve higher maximum RMS output power in multi-channel ap-

plications. This technology shows its strengths above all when not all channels require full power over the entire frequency spectrum at the same time. In active

operation, the DHR technology enables the channels that are responsible for the tweeter or midrange to have an even higher dynamic impulse output, from

which the entire audio system benefits. Thus, the Musway multi-channel amplifiers with DHR offer an effective and dynamic power reserve that is not available

in amplifiers with only one or two channels.