HOMCOM EF431K-E Bedienungsanleitung Seite 10

EN
EF821KB-E:
1) Connect the power
2) Turn on the power switch
3)Press the "ON/OFF" key of the remote controller to start up
4) Press the 1000W/2000W button once for the low heat setting 1000W; press twice for
the high heat setting 2000W; press three to switch off the heat setting.
5) Press the BACK LIGHT button to adjust the colours of LED decoration, 7 colours
available.
6) Press the COLOUR button for operate the colour mode, 7 colour available.
EF560K-E,EF452K-E,EF453K-E:
1)Connect the power
2)Turn on the power switch
3) Press the "ON/OFF" key of the remote controller to start up
4) Press the 900W button for the low heat settings; press twice to switch off the heat
setting.
5) Press the 1800W button for the high heat settings; press twice to switch off the heat
setting.
6) Press the COLOUR button for operate the colour mode, 7 colour available.
2. Automatic heating
Press "IC" button on the remote controller to start or exit the automatic heating.
When turned on, the fireplace can automatically change the heating mode depending
on the set temperature and the room temperature.
During a timed starting process, it is possible to start heating ahead of schedule.
3. Setting the day and time
1) Settings are done on the remote controller
2) Press "DATE TIME" button, then press the "▲" or "▼" key to select the day
3) Press "DATE TIME" button again, then press the "+" or "-" to set the hour
4)Press "DATE TIME" button again, then press the "+" or "-" to set the minute
5) Press "OK" button to complete
4. Temperature setting
The default set temperature is 20℃, press "+" or "-" on the remote controller to set the
temperature, which ranges from 15 to 30℃. And this setting is only for the
temperature in the normally mode, not for the temperature in the timer mode.
NOTE: The set temperature must be higher than the room temperature for the heat
working.
9