HOMCOM EF431K-E Bedienungsanleitung Seite 9

EN
Temperature and serial number display: Normally it displays the room temperature;
while setting the temperature, the setting temperature is displayed; When setting the
timer, serial number is displayed.
Time/ Temperature display: Normally it displays the current time; while setting the
timer, the setting time is displayed. When setting the temperature of the week timer, the
setting temperature is displayed.
Timer on and timer off: It is displayed while setting the timer, and it is used in
combination with serial number setting.
Colour flame: It displays the colour of the flame, which have 7 colour available.
Manual Operation
This is done by operating the switches located at the top right hand side of the fire .The
standby rocker switch must first be switched on, the fire will beep to indicate that it is
powered up.
Press the O/I button once to turn on the appliance and fire effect. A red indicator light
will show to indicate that the fire is ON. Press the O/I button for 3 seconds this will
operate the colour flame mode, hold the button down until the desired colour flame is
obtained, and there will be 7 colour available.
EF831K-E,EF851K,EF431K-E: Press the 1000W button once for the low heat setting;
press twice to switch off the heat setting. Press the 2000W button once for the high
heat setting; press twice to switch off the heat setting.
EF821KB-E: Press the POWER button once for the low heat setting 1000W; press
twice for the high heat setting 2000W; press three to switch off the heat setting.
EF560K-E, EF452K-E.EF453K-E: Press the 900W button once for the low heat setting;
press twice to switch off the heat setting. Press the 1800W button once for the high
heat setting; press twice to switch off the heat setting.
Remote Operation
The standby rocker switch located at the top right hand side of the fire must first be
switched on; the fire will beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the transmitter. Do not press the
buttons more than once within two seconds for the fire to operate normally.
1.Boot steps
EF831K-E,EF851K,EF431K-E:
1) Connect the power
2) Turn on the power switch
3)Press the "ON/OFF" key of the remote controller to start up
4) Press the 1000W button for the 1000W heat settings; press twice to switch off the
heat setting.
5) Press the 2000W button for the 2000W heat settings; press twice to switch off the
heat setting.
6) Press the COLOUR button for operate the colour mode, 7 colour available.
8