Roborock Qrevo Master Bedienungsanleitung Seite 8

Note: Placing a paused robot on the dock manually will
end the current cleanup.
Sleep
If the robot is paused for over 10 minutes,
it will go to sleep, and the power indicator
light will flash every few seconds. Press any
button to wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left sleep for
more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND is on, the robot will not
automatically resume cleaning, the power
indicator light will dim, and the volume of
voice messages will lower.
Mop Washing
During cleaning, the robot automatically
determines when it should return to
the dock for mop washing and water
tank refilling to maximize its mopping
performance. To manually start washing,
tap the corresponding button in the app.
Press any button to stop washing.
Notes:
• To make sure the robot to wash the mop cloths
automatically, start the robot from the dock and do
not move the dock during cleaning.
• To avoid burns from hot water, do not touch the water
outlets.
• Mop wash frequency and mode can be modified in the
app.
Emptying
After cleaning, the robot will return to
the dock and auto-emptying will begin
as needed. To manually start emptying,
press the button on the docked robot
or tap the corresponding button in the
app. Press any button to stop emptying.
Notes:
• When emptying has been left unused for a long
period, empty the dustbin manually and make sure
the air inlet is clear for optimal emptying performance.
• Auto-emptying can be disabled in the app.
• Avoid frequent manual emptying.
Drying
Drying starts automatically after mop washing
or after cleaning is completed. To manually
start or stop drying, tap the corresponding
button in the app.
Notes:
• Drying duration can be modified in the app.
• Auto-drying can be disabled in the app.
Charging
After cleaning, the robot will automatically
return to the dock to charge. Press the
button to send the paused robot back to the
dock. The power indicator light will breathe
during robot charging.
08
Note: If the robot fails to find the dock, it will
automatically return to its starting position. Place the
robot on the dock manually to recharge.
Error
If an error occurs, the power indicator light
on the robot will flash red or the status
indicator light on the dock will be steady
red. A pop-up notification will appear in the
app and a voice alert may sound.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually
will end the current cleanup.
Resetting the System
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system by pressing the Reset
button.
Note: After resetting the system, existing settings such
as scheduled cleaning and WiFi will be restored to
factory settings.
Restoring Factory Settings
If the robot does not function properly after
a system reset, switch it on. Press and hold
the button and at the same time, press the
Reset button until you hear the "Restoring
factory settings" voice message. The robot
will then be restored to factory settings.