Cleaning, Maintenance And Storage; Cleaning; Maintenance; Storage - Parkside Phsa 20-Li C3 Originalbetriebsanleitung

IE NI

Cleaning,

maintenance and

storage

WARNING! Risk of injury due to
unintentional start-up. Protect your-
self when performing maintenance or
cleaning work. Switch off the device
and remove the battery (9).
You should have any repair and main-
tenance work that is not described in
these instructions carried out by our
Service Centre. Only use original re-
placement parts.
Cleaning
WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemic-
al substances may attack the plastic
parts of the machine. Do not use any
cleaning agents or solvents.
• Keep the ventilation slits, motor
housing and handles of the ma-
chine clean. Use a damp cloth or
brush to do this.
Cleaning and maintaining the
safety cutter bar
Tools and aids required (not in-
cluded)
• Cloth
• Care oil spray
Care after each use
• Remove any green cuttings that
are stuck.
• Clean the safety cutter bar (2) with
an oily cloth.
• Maintain the safety cutter bar (2)
with a care oil spray.

Maintenance

• Check the device before each use
for obvious defects such as loose,
worn or damaged parts. Ensure
16
that the screws in the safety cutter
bar (2) are firmly in place.
• Check the covers and protective
devices (1/3) for damage and cor-
rect fit. Replace these if necessary
or have them repaired by the ser-
vice centre.
• You can smooth out slight nicks
on the cutting teeth yourself. To
do this, pull off the cutting edges
with an oil stone. Only sharp cut-
ting teeth provide a good cutting
performance.
• Blunt, bent or damaged safety cut-
ter bars must be replaced.
Have any work that is not described
in this instruction manual performed
by our service centre. Only use origin-
al parts.
Maintenance
Tools and aids required
• Hand protection (3, Spare parts
and accessories, p. 20)
• Phillips screwdriver (not included)
Replacing the hand protection
(Fig. D)
1. Loosen the two screws (17) on the
hand protection (3) with a screw-
driver.
2. Replace the damaged hand pro-
tection (3).
3. Fasten the new hand protection (3)
with the two screws (17).
Storage
Always store the device and ac-
cessories:
• clean
• dry
• protected against dust
• with blade guard (14) over the
safety cutter bar (2)
• out of the reach of children
The storage temperature for the bat-
tery and device is between 0°C and