Herunterladen Diese Seite drucken

Juskys 300494 Gebrauchs- Und Montageanleitung Seite 15

Vorschau ausblenden Andere Handbücher für 300494:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
4.3 Mounting height
The distance between the rain gutter and the wall bracket must be greater than or equal to 10 cm.
Wall bracket
Wall bracket
≥10cm
Floor
4.4 Drill holes
WARNING
Risk of injury and damage to property.
All screw holes must be aligned vertically and
horizontally so that the awning hangs straight.
►Check the alignment before drilling if you are
not sure.
►The diameter and depth of the fixing holes
must be the same size as the bolts.
Spring washer
Hexagon nut
Expanding bolt
Washer
thread
Washer
1. Drill the holes for the wall bracket [G-1] with a
Ø8 cm masonry drill bit.
2. Clean the drill holes.
Important: The holes must be drilled through a so-
lid brick or concrete to provide the necessary sta-
bility and support.
3. Remove the hexagon nut and washer, if not al-
ready done.
4. Press the bolts [G-3] into the drilled holes. You may
need to carefully tap the bolts [G-3] into the holes
with a soft-face hammer.
5. Check that the bolts [G-3] are firmly seated in
the drill holes but do not protrude more than
2.5 cm from the wall.
6. Place the wall bracket [G-1] on the threaded
7. Fit the threaded rods with one washer each.
8. Screw a hexagon nut onto each of the threa-
Wall bracket
9. Tighten the hexagon nuts with the spanner.
10. Repeat steps 3 - 9 for the other wall brackets.
4.5 Fitting the folding arm awning to the wall
Note: At least 2 people and 2 stable ladders are
required to install the folding awning.
1. Attach the side elements [D-1, D-2] to the wall
2. Tighten all hexagon head screws with a span-
Hammer
3. Check once again that all screws are tight.
4. Raise the awning fully using the hand crank [F]
If you are not satisfied with the height of the front
bar, refer to the following chapter.
rods of the bolts.
ded rods.
Cross section
of the wall
brackets [G-1].
ner.
and check the awning for stability. The front
pole should be horizontal.
Awning fabric
Front bar
Arm clamp
Helper
Side arm
Safety bolt
Cross section
of the wall
Tighten
Loosen to
adjust
EN
15

Werbung

loading

Diese Anleitung auch für:

300495300496300497