Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Clear the machine with gloves-leather, PVC material
2. Check the power cord, grounding failure circuit cut protection (GFCI) and plug. If
the plug is damaged, deformed or no grounding head, or the wire is damaged,
immediately replace and stop using the machine.
3. Check whether the appearance of the machine is intact, whether the parts are
defective and other factors affecting safety. Please confirm that the machine is in
good condition.
4. Clean the grease and dust on the handle to reduce the occurrence of various
dangers and easily control the machine.
5. Check whether the warning labels on the machine are attached and clearly
readable, and do not operate the machine without warning labels.
6. Clean and clear the sundries on the head and spring, check whether the spring
has been worn or damaged. If the spring is seriously distorted or seriously worn,
stop using the scrap immediately; Check the pin of the spring joint immediately,
otherwise the spring is in danger of falling into the pipe.
7. Check whether the dredging edge is sharp, otherwise replace the sharp
dredging head with the edge. Dredge the head is not sharp will affect the dredging
effect, resulting in spring bending, knot, and even fracture.
8. Lubricate the machine according to the operation manual, which can make the
normal use of the machine and prolong the service life of the machine.
9. Test the machine performance: connect to the power supply, Put the switch
knob to the CW and CCW gears to see if the machine can start properly, Place the
switch knob in the OFF gear, Whether the machine can stop turning, If normal start
and shutdown, Prove that the electrical part of the machine is normal, Place the
switch knob in the OFF gear; Pull a spring out of the spring basket and remove it,
Install the fuselage in the correct way in the operation manual, Press the clutch
handle, Pull the spring hard, The spring cannot pull out, Release the clutch handle
handle to bounce quickly; plug in, Place the switch in the CW position, Press the
- 9 -
Werbung
