STEINEL Professional L 400 S Bedienungsanleitung Seite 12

Installation / Wall mounting 2
The site of installation should be at least 50 cm
away from another light because heat radiated
from it may activate the system. To achieve the
specified max. reach of 12 m, the light should
be installed at a height of approx. 2 m.
Undo the screw on the top panel. Remove
screw and pull out wall mount.
Do not detach internal wiring from terminal
block, but gently pull out entire terminal
assembly.
Hold the mounting plate against the wall and
mark where to drill the holes, paying attention to
any wiring already existing in the wall, drill
holes; insert wall plugs. For the motion detector
to trigger a switching operation, the mains
power must be fed to the load by at least a
two-core cable. To do this, pierce the mounting
plate and fit sealing plug.
The mounting plate can be aligned and screwed
in place after feeding the cables through.
Connecting the mains power supply lead
The mains power supply lead is a 2 to 3-core
cable.
L = phase conductor
(usually black, brown or grey)
N = neutral conductor
(usually blue)
PE = any protective earth conductor
(green / yellow)
If you are in any doubt, identify the conductors
using a voltage tester; then disconnect from the
power supply again.
Disposal
Electrical and electronic equipment, accesso-
ries and packaging must be recycled in an
environmentally compatible manner.
Do not dispose of electrical and elec-
tronic equipment as domestic waste.
BLACK / BROWN / GREY
Connect phase conductor (L) and neutral con-
ductor (N) to the terminals to which a cable of
the same colour is already connected. Wrap in-
sulation tape around the end of the protective
earth conductor (PE).
Important: Getting the cable connections
crossed will produce a short circuit in the light
or in your fuse box. In this case, you must
check the identification of all cables and re-
connect them.
A mains switch for switching the light ON and
OFF can of course be installed in the mains
lead.
EU countries only:
Under the current European Directive on Waste
Electrical and Electronic Equipment and its
implementation in national law, electrical and
electronic equipment no longer suitable for use
must be collected separately and recycled in
an environmentally compatible manner.
- 12 -
BLUE
L N