cecotec CONGA 9590 SPIN REVOLUTION ULTRA POWER HOME Bedienungsanleitung Seite 36

ENGLISH
To replace the battery, follow the instructions below:
1. Unscrew the screws on the lower housing, remove the latter, and take out the battery.
2. Insert the new battery.
3. Put the battery and the lower housing back in place and re-tighten the screws.
5. TROUBLESHOOTING
Robot vacuum cleaner
Problem Possible cause and solution
The robot vacuum cleaner does not The robot vacuum cleaner does not work when
switch on or does not clean battery is low. Allow it to charge before operation.
The room temperature is below 0 °C or above 40 °C.
The robot vacuum cleaner isn't There are too many obstacles near the self-
charging or returning to the self- emptying base. Relocate the base to an obstacle-
emptying base free area.
Clean the charging terminals of the robot vacuum
cleaner and the self-emptying base.
Make sure the robot vacuum cleaner is switched on.
The robot vacuum cleaner is too far away from the
self-emptying base. Place it closer and try again.
The robot vacuum cleaner does not Turn off the robot vacuum cleaner and turn it on
work properly again.
Reset the robot vacuum cleaner by pressing the side
Reset button.
The robot vacuum cleaner makes a The main brush, side brush, or omnidirectional
strange noise during operation wheel are blocked or tangled. Stop the robot vacuum
cleaner and clean them.
70
Conga 9590 Spin Revolution Ultra Power Home
The robot vacuum cleaner does not The tank is full. Empty it and clear the high-efficiency
clean efficiently or doesn't pick up filter if it is blocked.
all the dirt
The high-efficiency filter is blocked. Clean it.
The main brush is blocked or tangled. Clean it.
The robot vacuum cleaner could not Bad Wi-Fi signal. Check that the robot vacuum
connect to the Wi-Fi network cleaner is located in an area with good Wi-Fi signal.
The Wi-Fi connection is unstable. Reset the router,
check if there are any App updates, and try again.
This robot vacuum cleaner only supports the 2.4
GHz band.
Make sure that your smartphone mobile data are
disabled to improve the linking process.
The robot vacuum cleaner did not Check if the robot vacuum cleaner is in Sleep mode
carry out the scheduled cleaning and change mode. This option can be found on the
task general settings of the robot vacuum cleaner and
allows you to define time slots in which the robot
will not perform the scheduled cleaning tasks when
in Sleep mode.
Ensure proper connection of the robot vacuum
cleaner to the Wi-Fi: you will not be able to carry out
scheduled cleaning without connection and with a
low battery.
The robot vacuum cleaner does not The robot vacuum cleaner will map and calculate a
return to the self-emptying base new route after running in Spot cleaning mode or
after finishing Spot cleaning or after changing its starting position.
changing the starting position
If the self-emptying base is too far away from the
robot vacuum cleaner, the latter won't be able to
return to the base. Manually move the robot vacuum
cleaner close to the self-emptying base.
The robot vacuum cleaner does not Make sure the robot vacuum cleaner is not in Sleep
resume cleaning mode, as it will not resume cleaning in this mode.
When manually placed in the self-emptying base,
the robot will not resume cleaning.
ENGLISH
71
Conga 9590 Spin Revolution Ultra Power Home