Werbung
GB
Display indicators
Water tank with microfibre mop pad
NOTE!
The water tankp is not designed for vacuuming liquids, but for damp cleaning of smooth surfaces.
1. Open the small cover and fill the tank with lukewarm water.
2. Close the cover again.
3. Attach the microfibre mop pad to the underside.
4. Place the water tank on the floor and insert the motorised electric brush into the recess from above so that the
electric brush is at the front. There is a magnet on the electric brush that holds the water tank in place.
5. The water flow can be switched on or off using the on/off switch (see fig. D)
6. After use, wash out the microfibre mop pad and empty the water tank.
NOTE!
The water slowly drips onto the mop pads during use, so we recommend that you moisten them once by hand
before use. For dry mopping, make sure that the on/off switch is set to „Off" and use a dry mopping pad.
24
Instruction manual
Battery charge status
Selected suction level
Air supply blocked
→ Check the suction pipe, suction opening and
accessories for dirt and clean them if
necessary.
Universal brush roller blocked / dirty
→ Remove the brush roller and clean it. Remove
hair and other dirt.
Cleaning the filter
→ Remove the filters and clean them.
→ If necessary replace the HEPA filter.
Overheating
→ The appliance switches off automatically if it
overheats.
→ Allow the hoover to cool down completely
before using it again.
→ Clean the brush roll and filter to eliminate the
cause of the overheating.
Werbung
