Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Pixel Dir
You can use this function to set the LED pixel direction.
Factory Setting
With this function, you can restore the factory settings of the device. The different settings (marked in the
Menu structure) will be set back to the default values (shaded).
INFO
Fixture Status
This function can be used to read out temperature data for the LED circuit board, display circuit board and
control circuit board. (see Menu structure)
Version C8.1.0
This function can be used to read out the software version.
RDM UID
This device supports RDM (Remote Device Management), which makes remote control of devices
connected to the DMX bus possible. ANSI E1.20-2006 by ESTA specifies the RDM standard as an extension
of the DMX512 protocol. RDM simplifies device configuration as manual settings like adjusting the DMX
starting address are no longer needed. RDM is integrated in DMX without influencing the connections. The
RDM data is transmitted via the standard XLR pins 1 and 2 – new DMX cables are not necessary. RDM-
ready and conventional DMX devices can be operated in one DMX line. The RDM protocol sends own
packages in the DMX512 data feed and does not influence conventional devices. DMX splitters, however,
must support RDM. Which parameters can be called up via RDM depends on the RDM controller used.
Master/slave operation
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1
Configure all slave units before connecting the master unit. Use the UP or DOWN button to select
MODE. Confirm with the ENTER button. Use the UP or DOWN button to select M/S Choose in the
display. Confirm with the ENTER button and press the ENTER button until Slave appears on the display.
2
To define the master unit, use the UP or DOWN button to select MODE. Confirm with the ENTER
button. Use the UP or DOWN button to select M/S Choose in the display. Confirm with the ENTER
button and press the ENTER button until Master appears on the display.
3
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
4
Select the desired setting at the master unit. The interconnected devices will now operate
synchronously.
36/44
00159041, Version 1.0
Werbung
